Nokia 3710 fold Earpiece Speaker Failure Solution - we say welcome to you who have been searching for information via search engines such as Google, in a blog
Tech Gallery, now we will discuss information about the Nokia 3710 fold Earpiece Speaker Failure Solution , we have been looking for a lot of information from a trusted and collect it in this blog, so you get the information complete and easy to understand, please read through:
Article Nokia 3710f,
You can also see our article on:
If the there is no sound can be heard on Nokia 3710 earpiece speaker, this problem may possibly caused by a faulty speaker, a corrupted flash firmware, a damaged flex wire, oxidation build up due to wet damaged, weak contact terminal pads and possible damaged components within the PCB board circuit.
This solution below can be used for further troubleshooting if already doing a check up and found out that the speaker is okay, the flex wire is good and working and or already tried installing a new replacement, the PCb board is already cleaned.
Nokia 3710 fold Earpiece Speaker Repair Solution
The components highlighted on the solution above is mounted or located near the flex pin connector and the application processor chip. These components are composed of a filter coils, resistors and an ESD protection chip. These is where the audio signal flow across this components which is feeds from the Audio IC (GAZOO).
You may check each of these components and replace if found damaged to possibly fix Nokia 3710 earpiece speaker problem.
0 comments:
Post a Comment